Skip to main content

Special brass, with non-return valve, strainer can be unscrewed.

Accessories

Brass pipe-to-hose fitting
Brass hose - to - pipe fitting with external threads and hexagonal wrench attachment points. Available for various hose diameters.

From €3.20 *
Brass pipe-to-hose fitting 90° with external thread
Hose connector from brass, angled 90°.With exterior threads and hexagon.For a variety of hose diameters.

From €4.90 *
Brass pipe-to-hose fitting 45° with external thread
45° elbow hose nozzle made of brass, with external thread and attachment for screwing in. For various hose diameters.

From €10.30 *
Brass reducer with external thread
Brass reducers. BSP outer threads on both ends (thread sizes are the nominal sizes, not the diameter).

From €3.50 *
Brass reducer with internal/external thread
Bronze reducers.BSP inner and outer threads.The thread sizes are the nominal sizes and not the diameter.

From €3.30 *

Similar products

Brass screw-in sieve filter with stainless steel sieve
Screw-in sieve filter consisting of a brass body with an inch external thread and a sieve made of A2 stainless steel.Good for protecting the pump from coarse impurities when drawing in outside water or bilge water. Depending on the intended use, we recommend screwing the suction basket into a standpipe, a pipe-to-hose fitting or a non-return valve. See the example photos with corresponding accessories (not included in the scope of delivery).

From €6.90 *
Bilge strainer WHALE
With integrated check valve for hoses of 25 mm and 38 mm.With sieve on the onboard side.

€35.90 *
Bilge strainer WHALE
With integrated check valve for hoses of 25 mm and 38 mm.With sieve on the outboard side.

€35.90 *
Bilge strainer WHALE
Bilge strainer with check valve, easy to clean.With 19 mm hose connector.The connector can be mounted in three directions: standing, horizontal, sideways.

€64.90 *
Bilge water filter (oil strainer) WAVESTREAM
The MARPOL Convention prohibits the discharge of oily wastewater into the sea. This filter removes the oily substances from the pumped bilge water by a patented filter system, so that the bilge water can be pumped out almost without oil residues and the water pollution is minimized.The filter is installed behind the bilge pump and in front of the ship's passage. It is suitable for oil residues, large dirt must be removed from the bilge before.Supplied with a stainless steel wall mounting plate.Replacement filter cartridges are available, annual replacement is recommended.LLOYD'S REGISTER Type Approved.

From €179.00 *
Transparent multiflex hose PVC
Transparent, thick-walled hose made of flexible PVC with inserted steel spiral for use as a suction or pressure hose. Well suited for bilge pumps and bilge and grey water systems.Limited resistance to oil and grease (may harden).

From €3.95 *
Multiflex hose PVC
Green transparent PVC hose for drinking water, bilge pumps (also suction side) and on-board toilets.Spiral strengthened and thick-walled version for use as suction or pressure hose.Approved for human consumption. Limited resistance to oil and grease (may harden).

From €4.90 *
Thru-hull hose fitting polished or chromed
Through-hull with attached hose nozzle. Made of brass (seawater resistant brass, depending on manufacturer CW602N - CuZn36Pb2AS or CW625N - CuZn35Pb1,5AlAs).Comes in rolled brass or with a chromed finish.The outer thread in nominal thread size is BSP.

From €11.00 *

Last seen products