Bent tank vent.Brass, polished or chromed finish.All vents have metal sleeves.Intended for a maximum hull thickness of 15 mm.Gland for hose D = 16 mm.Available with the gland bent upwards or downwards.
Bent fully countersunk tank-vent fitting.Brass. Polished or chromed finish.All vents have metal sleeves.Intended for a maximum hull thickness of 15 mm.Available with gland above or below.
Countersunk design, stainless steel (AISI 316) bright polished. The ventilation system has a flame protection screen and a spritz cap. Installation: From the outside with screws. The spritz cap can be turned depending on the installation situation.
Countersunk design, stainless steel (AISI 316) bright polished. The ventilation system has a flame protection screen and a spritz cap. The spritz cap can be turned depending on the installation situation. Installation: From the outside with screws.
This practical fitting should always be built in to the vent lines of fuel tanks.When filling, the escaping air makes a whistling noise. Shortly before the tank is full, it skips over to a trilling.The filling can thus be stopped in time, hindering the overflow of fuel and the pollution of the water.Material:Plastic,with 16 mm hose attachments on both sides,length 95 mm.
Countersunk design, stainless steel (AISI 316) bright polished. The ventilation system has a flame protection screen and a spritz cap. Installation: From the outside with screws. Fuel tank ventilation for large hose diameters.
Countersunk design, stainless steel (AISI 316) bright polished.The ventilation system has a flame protection screen and a spray cap.Depending on the installation situation, the spray cap can be rotated so that the hose connection can be used in any desired position.Installation: From the outside (hidden) with counter-clamp and two threaded bolts (wall depth, max. 15 mm).
Countersunk tank vent of polished stainless steel (AISI 316), with 19 mm hose diameters.The vents have a flame-protection screen and a spray cover.Installation: from the inside with threads and nuts (max. wall thickness 15 mm).