High-quality, smooth running gear cable for push (max. 35 kg) and pull transmission (max. 70 kg) between gear shift and engine.Rust-free inner core with threaded terminals, steel-armed nylon covered patented inner octagon for smooth running.Outer diameter 9 mm, sealed against water and dust, pivoting area max 8°, max travel 75mm.Smallest bending radius 200mm.Imperial threads No.10-32 UNF.Also comes in intermediate lengths (gradation 1') and in larger lengths up to 40'.
For the cut-off switch on diesel engines or as choke cable.Stainless steel inner core, D = 1.9 mm, one side with threaded terminal and red plastic pull handle, open on the other side.Steel-reinforced nylon sheath, black.On the handle side with attachment fittings and nuts.Can be shortened to any length.Further accessories (see below "Accessories") are available:angle mountingconnection sleeve with nutlock nipple
The double-station connector (DS Units) connect the 33C cables of two control stations to a single cable. DS Units are mounted in the engine room, close to gearbox and injection pump.Two units are required, one for gearshift, one for speed.To change the station, all levers must be in neutral position.Max. stroke 75mm. Strong design of aluminum base, plastic body and inox axles.. Dimensions: L x W = 145 x 60 mm.Comes with fork end.
RCS Marine pull-push cables for the smoothest running, exceptionally small bending radius or larger transmission between gear and engine.Type 284 V:travel 76mm,bending radius 51 mm,end threads No. 10-32 UNF,outer diameter = 9 mm,max. pivoting area 8°,blue.All end pieces made of stainless steel. Teflon protected core . Steel-armed plastic cover. Lubricated, effective end seal.Available in lengths from 1 m to 20 m in 25 cm steps.(delivery time approx. 1 week).
The push-pull cable type 23 is dual-purpose for outboard motors as well as inboard engines.Rust-free inner core with threaded terminals from stainless steel with UNF fine pitch thread 10-32, suitable for almost all gear drives.The gearshift cable has a max travel of 75 mm, the outer mantle (diameter 7 mm) colour is black. Smallest bending radius is 200 mm.Shipping in lengths of 5' (1,52 m) up to 20' (6,10 m).
Pull cable KOBELT 2090: Special pull cable to connect master (main) and remote (auxiliary) stations in a two stations system KOBELT 2091 / 2093 or 2092/2094.Two cables are required for each machine to connect the stations (one cable each for speed and gearbox).In addition to the lengths specified here, which we have in stock, the cables can also be customised according to your exact length specifications. Please order the cable 4908-000 here in the webshop and specify the desired length in the last step of the ordering process under "Remarks".Alternatively, you can of course also request a customised quotation by telephone or e-mail.Lengths up to 10.00 m are available. The delivery time for customised dimensions is approximately one week.
