Battery chargers

For recharging the onboard batteries or onboard accumulators you need a good marine or boat battery charger. The electronic circuit contained in the device, the charge controller, controls the charging process and implements the charging procedure. In our range of marine equipment, you will find reliable, tried and tested devices. With high-performance battery chargers, multiple banks of batteries can be charged, whereby the device's adaptive battery management adapts the charging process to operating conditions. Some types have a remote control or can be …

Battery Charger IP65 VICTRON BLUE SMART

Ultra-highly efficient, fanless battery charger with an efficiency of up to 95 %.Selectable charging mode according to 7-stage charging curve (also suitable for lithium batteries) with recovery function for deeply discharged, "dead" batteries.Practical for the workshop, 230 V ready to plug in, can be connected on the battery side with crocodile clips or with M8 cable lugs. Protected against reverse polarity, output short circuit and overheating.With built-in Bluetooth, can also be configured from a mobile phone or tablet via app.Splashproof and dustproof to IP65.

From €115.00 *

Details

Battery charger STERLING ProSport

Quality battery charger: Absolutely waterproof (IP68). PS125 with one outlet, the other models with two (or three at PSP12203) equal outlets for several battery banks. The isolated outputs can be coupled to charge 24 V (36V with PSP12203) batteries.Switch-mode technology allows compact dimensions and light weight. Load characteristics (3-step IUoU) for lead-acid, gel cell or AGM batteries. PS125 and PS1255 for lead-acid and gel batteries only, charge voltage 14,4/28,8V). Watertight moulded plug and charging cords (L=150cm), come with terminal crimpers and fuses.Power factor correction PFC on PSP models. Compact unit for use under severest operating conditions, salt water proof. - Input voltage 200 - 250V, 45-55Hz - Protected against overheating - Reverse-polarity and short cut protection - Power factor correction on PFC models - Parallel wiring of multiple units is possible (doubling the capacity) - Watertight (IP68), salt-water tested - Strong moulded plastic/metal housing.

From €139.00 *

Details

STERLING alternator protection ProProtect A

The Pro Protect A from Sterling protects the alternator and is installed in the charging circuit between the alternator and the battery bank.If the charging circuit is interrupted while the alternator is running, e.g. due to unintentional actuation of the battery disconnect switch or tripping of a fuse, the alternator will not be charged. The excess energy can damage the alternator's charge controller.The alternator protection consumes the excess energy in the event of a fault. Tripping is signalled by a red LED. An external alarm or signalling device (see accessories) can be connected via a switching contact (max. load capacity 1A).

From €92.00 *

Details

Alternator to battery charger STERLING ProAlt C

STERLING ProAlt C:Highly efficient alternator-to-battery-charger (A2B). A simple generator with standard regulator is a very ineffective battery charger. The A2B charger optimizes the charging performance of the generator. Quick and easy installation !The house batteries are charged through an isolated output with 4-step IUoUo charging. No further split diodes are required! The starting battery is always charged preferentially (separated output), ensuring a safe motor start. The A2B charger offers the following functions: - Easy installation, even for nonprofessionals - No changes to the generator - IUoUo charging characteristics for house battery - For lead-acid, gel-cell or AGM batteries - Fully automatic adaptation of the balance charging - Automatic battery size recognition - Gold-plated output terminal - Protected against surges and overheating (includes temperature sensors) - Protected against overloads - Parallel connection of several units is possible (boosting the capacity).Optional remote controls are available:ABNRC remote (only for chargers AB1280, AB12130 and AB2480): small 2 line display, 2 LEDs, remote switches,ABRC remote (for all other chargers): two line diplay, remote switches. Comes with two shunts, also displays charging current (A).Choose the right size of your charger by the maximum charging current of your geneator!The remote control ABNRC only works with the AB1280 and AB12130. The remote control ABRC works with all other A2B chargers.

From €529.00 *

Details

0% VAT in Germany

Inverter-charger VICTRON MULTIPLUS-C

Combined battery charger and inverter (to generate 230 V from the onbard battery). VICTRON ENERGY units have been developed on the basis of modern hybridhigh-frequency technology for professional use. The foundation for the MULTIPLUS assumes an efficient sine alternating current, connected with a battery charger and an automatic switch, all combined in a compact blue hausing: The clean sine alternating current allows undistributed use of all -- even electrically sensitive -- units, even those with high starting currents. At peak performance the unit provides 200% of the nominal power. USV function: the switch from inverter to generator - or shore power -happens automatically and so quickly that, for example, a computer can continue to work without interruption. The battery charging takes place over a 4-step adaptive load, so that the required charge is achieved. A second power output charges the starter battery using a 1-step process. Intelligent installation and control possibilities. Optional remote available. Weight 18 kg.- Battery charging with 4-step adaptive charging - Separate charging for starter battery- Inverter produces a clean sine alternating current- Automatic switching to external power source (USV function)- Control LEDs on the unit- Very good radio interference suppression- Optional remote control panel

From €799.00 *

Details

0% VAT in Germany

VICTRON MULTIPLUS Inverter/charger

Combined battery charger and inverter. VICTRON ENERGY devices are developed on the basis of the latest hybrid high-frequency technology for professional use.The basis of the MULTIPLUS is a powerful sinus inverter, combined with a battery charger and an automatic transfer switch in a compact blue housing.The pure sine wave alternating voltage enables trouble-free operation of electronically sensitive devices, even with high starting currents. The device can deliver 200 % of the rated power as peak power.With UPS function: Switching from inverter operation to generator or shore power takes place automatically and so quickly that computers, for example, can continue to work without interruption.The battery is charged according to a four-stage, adaptive charging characteristic so that exactly the required current is always supplied. A second charging current output charges the starter battery in a single stage.With intelligent setting and monitoring options and control LEDs on the device.Very good interference suppression.Optional remote control / control panel Digital Multi Control.The specified continuous output refers to an ambient temperature of 25 °C, with a non-linear load.For further details, please request our TOPLICHT-Info 101 (VICTRON).Translated with DeepL.com (free version)

From €454.90 *

Details

0% VAT in Germany

VICTRON DIGITAL MULTI-CONTROL remote control panel

Info: 0% VAT on this article in Germany. Digital remote control for all Multiplus inverters/chargers. The operating mode of the Multiplus can be set using a toggle switch. LEDs indicate the operating mode, charging phase and warnings. The maximum charging current can be set via a rotary knob and a display. Setting range up to 200 A.A built-in sensor automatically reduces the brightness of the LEDs in the dark.

€187.00 *

Details

Charger VICTRON CENTAUR

Battery charger VICTRON CENTAUR: Microprocessor controlled high-performance charger for three battery banks with temperature adapted 3-stage charging characteristic. At a glance: - Protection category IP21 (protection against water condensation), - circuit boards are protected with an acrylic coating for maximum corrosion resistancec,- the charging capacity is temperature-controlled, - the blue aluminium housing is suitable for the engine room, - optional extra: interface for remote control, monitoring and computer assisted setting of all parameters, - three isulated outputs, each outpud is capable to supply the full rated current, - all models will operate without any adjustment needed over a 90 to 265 V, 50-60 Hz input voltage range, - for all battery types (lead acid, Gel, AGM), - mode for power supply unit, overheating protection, reverse polarity and short circuit protection.

From €389.00 *

Details