Further accessories and spare parts can be found directly with the respective pumps.
- Rigg & sail
- Rope & cordage
- Anchoring & mooring
- Hull & deck
- Cabin & comfort
- Paint & boatbuilding
- Electrics & engine
- Pumps & sanitation
- Safety & VHF radio
- Navigation & books
- Commercial shipping
Spare parts & accessories for pumps
Impeller IMP2 of special nitril rubber. Original spare part for UP1-J and UP1-JR MARCO pumps.Dimensions hight x Ø: 22 x 40.5 mm.Bore Ø: 8 mm.
For electric impeller pumps.Protects the pump against damage by dry run.The switch is installed on the sucction side of the pump. Cuts the power supply when the pressure drops, caused by a lack of water.Connected to the sucction tube by 1/4" BSP.
Spare handle for WHALE GUSHER 10 and WHALE TITAN bilge pump.Inox tube with black plasic knob.
Deckplate for WHALEpumps for deck or bulkhead mounting. Provides a neat cover over manual bilgepumps. Manufactured from UV stabilised plasic, will not fade or discolor. Snap-shut lid remains closed when pump is not in use.Article-no. 1860-110 (DP8904) fits for Gusher 10, Urchin, Titan.
Deckplate for WHALE-pumps for deck or bulkhead mounting. Provides a neat cover over manual bilgepumps. Manufactured from aluminium cast. Snap-shut lid remains closed when pump is not in use. 1860-111 (DP3804) fits for Gusher 10 and 30 or Gusher Urchin.
This service kit fits for WHALE GUSHER 25 pumps which are produced before 1989.
Spare parts for WHALE GUSHER 30 bilge pump.The service kit (neoprene) contains all wearing parts for the GUSHER 30:2 membranes2 dampers2 inlet valve & seal1 outlet valve2 holder valves2 Valve gasket4 Nylon M10 washers2 screws No 6x11/4"The replacement lever is made of stainless steel (450mm) and is supplied with a safety line.A detailed overview of spare parts can be found under "Downloads". We can supply all spare parts on request.
Deckplate and bridge for WHALE-pump Gusher 30, for deck or bulkhead mounting. Provides a neat cover over manual bilgepumps. Manufactured from aluminium cast. Snap-shut lid remains closed when pump is not in use.
These standard spare parts fit to our cast iron diaphragm pump TII (Art-Nr. 1878-001).
Spare handle for HENDERSON/WHALE MK5 pumps.Inox tube with black plasic knob.
Deckplate for HENDERSON/WHALE pump MK5 for deck or bulkhead mounting. Provides a neat cover over manual bilgepumps. Manufactured from UV stabilised plasic, will not fade or discolor. Snap-shut lid remains closed when pump is not in use.
Accessories for electric diaphragm pump EVS.
Accessories for bilge pump HENDERSON/WHALE COMPACT 50.
Holding brackets, fit our brass hand bilge pump.Stainless steel.
Accessories for brass hand bilge pump, manufactured before 2012.
Spares for FYNSPRAY galley pumps AUCKLAND or DUNEDIN.
Spare piston forFYNSPRAY galley pumps.Piston ao brass and seal of rubber.
Spareparts for the bilge- and wastewater pump Raske & van der Meyde. The service kit 921 includes: Nr. 310.22* membrane Nr. 911* valve set Nr. 912* O-ring
