WEMA tank sensor diesel NMEA2000/200mm
Highly reliable transducer for diesel tanks, which is simply connected to the NMEA2000 network of a ship via the built-in plug and play. The level is measured contact-free via reed contacts using a float with a ring magnet. The electronics of the N3 model are encapsulated and therefore completely insensitive. The data can be displayed via a multifunctional display, the plotter or a WEMA display for NMEA data. The N3 encoder can be easily removed for maintenance or in the event of blockages.
Important note: The NMEA2000 transducers from WEMA must be programmed for the intended use before delivery, i.e. the fluid type and tank number must be assigned. The transducers listed here are all factory-set for use with diesel tanks and tank no. 1. If you need the sensor for water or waste tanks, please order the alternative articles for diesel or waste tanks here in the store. If you require other tank numbers, these can be ordered from the manufacturer as preset, please ask.
Installation is carried out using a 1 1/4" BSP thread in the tank or with the help of a corresponding carrier adapter, which is screwed into the tank (not included in the scope of delivery, see accessories below). Thanks to this design, the sensor can be unscrewed quickly and easily for inspection or cleaning.
The manufacturer recommends selecting the length of the sensor so that there is a minimum distance of 2.5 cm and a maximum distance of 5 cm from the bottom of the tank.
The connection cable is 99 centimeters long. 1 1/4 inch thread, connector: NMEA Male .
Technical data
- Stainless steel transducer with float and reed contacts
- Power supply: 12 V via NMEA2000 connection
- Protection class IP65
- 1 1/4 inch thread
- Connector: NMEA Male
from €169.90*
€169.90*
Prices incl. VAT plus shipping costs
Description
Highly reliable transducer for diesel tanks, which is simply connected to the NMEA2000 network of a ship via the built-in plug and play. The level is measured contact-free via reed contacts using a float with a ring magnet. The electronics of the N3 model are encapsulated and therefore completely insensitive. The data can be displayed via a multifunctional display, the plotter or a WEMA display for NMEA data. The N3 encoder can be easily removed for maintenance or in the event of blockages.
Important note: The NMEA2000 transducers from WEMA must be programmed for the intended use before delivery, i.e. the fluid type and tank number must be assigned. The transducers listed here are all factory-set for use with diesel tanks and tank no. 1. If you need the sensor for water or waste tanks, please order the alternative articles for diesel or waste tanks here in the store. If you require other tank numbers, these can be ordered from the manufacturer as preset, please ask.
Installation is carried out using a 1 1/4" BSP thread in the tank or with the help of a corresponding carrier adapter, which is screwed into the tank (not included in the scope of delivery, see accessories below). Thanks to this design, the sensor can be unscrewed quickly and easily for inspection or cleaning.
The manufacturer recommends selecting the length of the sensor so that there is a minimum distance of 2.5 cm and a maximum distance of 5 cm from the bottom of the tank.
The connection cable is 99 centimeters long. 1 1/4 inch thread, connector: NMEA Male .
Technical data
- Stainless steel transducer with float and reed contacts
- Power supply: 12 V via NMEA2000 connection
- Protection class IP65
- 1 1/4 inch thread
- Connector: NMEA Male
Downloads
