Wema encoder water tank NMEA2000
Highly reliable transducer for water tanks, which is simply connected to the NMEA2000 network of a ship via the built-in plug and play. The level is measured by means of a float with ring magnet without contacting the reed contacts. The electronics are encapsulated and therefore completely insensitive.
Important note: The NMEA2000 transducers from WEMA must be programmed for the intended use before delivery, i.e. liquid type and tank number can be assigned. The transducers listed here are all factory-set for use with water tanks and tank no. 1. If you need the sensor for diesel or waste tanks, please order the alternative articles for diesel or waste tanks here in the store. If you need other tank numbers, these can be ordered from the manufacturer as preset, please ask. Alternatively, you can order your own
Installation is carried out using a 1 1/4" BSP thread and corresponding support adapter, which is screwed into the tank (not included in the scope of delivery, see accessories below). Thanks to this design, the sensor can be unscrewed quickly and easily for inspection or cleaning.
The manufacturer recommends selecting the length of the sensor so that there is at least 2.5 and a maximum of 5 cm distance to the tank floor.
The connection cable is 99 centimeters long. 1 1/4 inch thread, NMEA male connector.
€0.00*
Description
Highly reliable transducer for water tanks, which is simply connected to the NMEA2000 network of a ship via the built-in plug and play. The level is measured by means of a float with ring magnet without contacting the reed contacts. The electronics are encapsulated and therefore completely insensitive.
Important note: The NMEA2000 transducers from WEMA must be programmed for the intended use before delivery, i.e. liquid type and tank number can be assigned. The transducers listed here are all factory-set for use with water tanks and tank no. 1. If you need the sensor for diesel or waste tanks, please order the alternative articles for diesel or waste tanks here in the store. If you need other tank numbers, these can be ordered from the manufacturer as preset, please ask. Alternatively, you can order your own
Installation is carried out using a 1 1/4" BSP thread and corresponding support adapter, which is screwed into the tank (not included in the scope of delivery, see accessories below). Thanks to this design, the sensor can be unscrewed quickly and easily for inspection or cleaning.
The manufacturer recommends selecting the length of the sensor so that there is at least 2.5 and a maximum of 5 cm distance to the tank floor.
The connection cable is 99 centimeters long. 1 1/4 inch thread, NMEA male connector.
