HEMPEL PRE-CLEAN cleaner / degreaser

Cleans tools, paint brushes and other working material. Effective for metal cleaning, epoxies, polyester resin and fiberglass. Can be used as thinner for many products. Degreases sanded surfaces.

Fast-volatile and effective agent for cleaning and degreasing surfaces before painting or bonding. Dissolves fresh paint and adhesive residues without causing lasting damage to the surface.

Hight purified paraffin, for cleaning tools and all paraffin-resistant surfaces.Dissolves oil, grease and wax.

Methylated spirit - 1 litre bottle.

Before every painting and protection job, a proper and professional cleaning of the surface is necessary. This highly effective cleaner removes oil, grease, fuel, and even silicone residues reliably from painted or GRP finishes. Not intended for cleaning raw wood.

Highly effective, biodegradable paint remover and softener based on renewable raw materials. LE TONKINOIS Natural Brush Cleaner removes fresh and dried paint residues from painting, varnishing, and artist tools. Gentle cleaning of brush bristles, also suitable for natural hair brushes. Easily dissolves fresh as well as dried residues of paints, varnishes, oils, waxes, and other stubborn contaminants. It conditions the bristles, especially natural and China bristles, and prevents them from drying out. The cleaner is also suitable for storing brushes, as it hardly evaporates and remains usable for a long time.Application: Shake well before use. Dip dirty tools into LE TONKINOIS NATURAL BRUSH CLEANER, knead thoroughly and then rinse with water until the water runs clear. For heavily dried material, soaking overnight is recommended. Then knead and rinse the tools again. The cleaner is very economical and remains effective even when discolored.Safety information: contains orange oil, may cause allergic reactions. For safety, wear gloves when using.Further information on processing can be found in the technical data sheet under 'Downloads'.

A cleaning and brightening agent for treating grayed wood surfaces. The formulation of LE TONKINOIS Wood Brightener is based on nature-identical oxalic acid and coconut fatty acid active ingredients and is suitable for hard- and softwood in outdoor areas, such as decking or garden furniture. The brightener reliably removes weather-related discoloration and prepares the wood for subsequent surface treatment.Application: Shake well before use and apply generously with a brush. Do not use in direct sunlight. Moisten wood with water if necessary. After a reaction time of 10–15 minutes, scrub with a hard brush or abrasive fleece and water. Then rinse thoroughly with water and allow to dry completely. The surface will be rough afterward and should be sanded before further treatment.Technical DataApplication area: Brightening and cleaning of grayed hardwood and softwood, e.g., decking and garden furnitureSubstrate: All woods, roughly pre-cleanedCoverage: Min. 100 ml/m², depending on the wood's absorbencyApplication method: Brush and scrubberDrying times (at 20 °C): 1–2 days depending on weather conditionsFurther information on application can be found in the Technical Data Sheet under 'Downloads'.

Versatile water-based industrial cleaner for stubborn soiling on almost all surfaces. Whether oil films, grease deposits, soot or adhesive residues - OWATROL PURATROL removes even heavy residues thoroughly and gently. The alkaline cleaner is suitable for indoor and outdoor use, on horizontal and vertical surfaces, e.g. plastic windows, awnings, garden furniture, machines or workshop floors. PURATROL is also ideal for degreasing before painting. The cleaner is available as a concentrate and can be diluted with water as required. Subsequent neutralization is recommended for wooden surfaces to prevent any darkening.Application: Do not apply to hot surfaces. Ensure good ventilation. Dilute the concentrate in a ratio of 1:5 to 1:20. Apply the product and leave to work for ten minutes. Remove soiling with a brush or cloth, wash off cleaning agent residues with clear water. Repeat the application for heavy soiling &nbsp

Special cleaner and brightener for weathered and soiled wooden surfaces, especially teak decks. Also cleans GRP, gelcoat and particularly non-slip or textured deck coverings, removes yellowing and rust stains. Greyed teak decks regain their original wood tone, tannin-rich woods such as oak can be neutralized before recoating.OWATROL DECK CLEANER should be used to neutralize the wood after using alkaline deep cleaners such as DEEP CLEANER. The cleaner is based on oxalic acid and is biodegradable.Safety note: Wear chemical-resistant gloves, safety goggles and protective clothing when using.Application: Moisten absorbent substrates such as wood with water. Homogenize container by shaking. Apply evenly, then allow to act for 10-20 minutes. Ensure the surface remains wet during this time (e.g., with a garden hose). After the exposure time, rinse thoroughly with a brush or pressure washer to remove dirt from the pores. In heavily stained areas, repeat the application if necessary. Wait at least three days before further treatment with oils or varnishes (e.g., OWATROL DECK SEALER or AQUADECKS). Technical DataApplication area: Cleaning and brightening of greyed wood in outdoor areasSubstrate: untreated or oiled wood, moisten before applicationApplication: Brush, scrubber, sponge, watering can, sprayerCoverage: approx. 5–10 m²/l depending on degree of soilingThinning: undiluted or dilutable with water up to 1:5 Processing temperature: +5 °C to +35 °CDrying (20 °C): rinse off after 10–15 min., then allow wood to dry for 48 hrsFurther information on application can be found in the technical data sheet under "Downloads".

PANTASOL LIGHT is a purely distilled cleaner with natural lemon extracts without acetone and xylene that is ideal for preparing bonding and varnishing. PANTASOL LIGHT vents completely without leaving any residue. Especially recommended for sensitive surfaces, does not even attack polystyrene. Ideal for removing sticker residues, grease, adhesive, oil, wax, preservatives, fresh epoxy adhesives, silicone, PU and SMP sealants. It does not attack fully hardened paints and is neutral to most plastics (test first), does not leave an oil film.Container: 1-litre can or 500 ml spray bottle

Silicone remover is a high-quality cleaner with a short evaporation time. Suitable for the complete removal of silicone oil residues, greases, oils and waxes before coating or sealing.

White Spirit is a turpentine substitute and a mineral oil-based thinner. The product is used to thin paints based on oil and oil-alkyd resin, as well as a cleaning agent for parquet, linoleum, and brushes. It is characterized by consistent quality and good material compatibility.Application: The product is added to the respective paint and mixed. The maximum amount depends on the manufacturer's specifications of the respective paint. In addition, white spirit can be used to clean used painting tools such as brushes. Always close tightly after use and store in a cool, but frost-free place.Technical DataField of application: Thinner for paints based on oil and oil-alkyd resin; cleaning agent Substrate: Painted surfaces, used toolsCoverage: depends on the paint system and desired viscosityDrying times: depends on the paint system usedFurther information on processing can be found in the technical data sheet under 'Downloads'.