Paint remover
EPIFANES Paint Remover
€45.20 *
Effective and odorless paint stripper for almost all 1- and 2-component paints and varnishes, as well as for antifoulings and epoxy primers on all common boatbuilding materials.Non-evaporating, PH neutral, biodegradable, contains no alkalis, acids or biocides and is harmless for the following coating. Can be used below freezing point.Application: Stir well before use. Apply a thick coat with a soft, long-haired brush. After use, remove all residual material before applying a new coat. Avoid repeated overbrushing. Reaction time may take from 30 minutes to 24 hours, depending on the layer of paint to be removed. Make a small test trial on the surface to check the compatibility. The best way to remove treated layers is with a knife or spatula. Other paint and paint stripper residues can be washed from the surface with water.
YC-ANTIFOULING-STRIPPER paint stripper 2.5l YACHTCARE
€64.90 *
colour:
transparent
|
contents:
2,5 i
YACHTCARE ANTIFOULING STRIPPER is a gel-like, highly effective remover for antifouling coatings. The product loosens existing antifouling layers in a short time, allowing them to be easily removed mechanically, without sanding. Due to its gel-like consistency, the material also adheres to vertical surfaces. Gelcoat and intact 2-component primer layers beneath the antifouling are not attacked.Application:Apply ANTIFOULING STRIPPER evenly to the surface using a wide brush. Then leave it to act for about 60 minutes up to a maximum of 2 hours. Scrape off the loosened paint layers with a spatula. Repeat the process if necessary until all coatings are removed. Collect paint residues and dispose of them properly. Protect adjacent surfaces.For safety, it is recommended to wear protective gloves and goggles during application. Then thoroughly clean the surface with fresh water and allow it to dry completely. Technical DataApplication area: Removal of antifouling coatingsSubstrate: GRP, wood, steel, aluminumCoverage: approx. 200–600 ml/m² (depending on the thickness of the old coating)Application and surface temperature: +5 °C to max. +25 °C.Thinning: noneApplication method: brush, mechanical removal with spatula For more information on application, see the Technical Data Sheet under 'Downloads'.
Content: 0.7519 Liter (€86.31* / 1 Liter)
